Table of Contents
Advertisement
Figure 279 IP Application > DiffServ
The following table describes the labels in this screen.
Table 186 IP Application > DiffServ
LABEL
Active
Port
*
Active
Apply
Cancel
43.3 DSCP-to-IEEE 802.1p Priority Settings
You can configure the DSCP to IEEE 802.1p mapping to allow the Switch to prioritize all traffic based on
the incoming DSCP value according to the DiffServ to IEEE 802.1p mapping table.
The following table shows the default DSCP-to-IEEE 802.1p mapping.
Table 187 Default DSCP-IEEE 802.1p Mapping
DSCP VALUE
IEEE 802.1p
43.3.1 Configuring DSCP Settings
To change the DSCP-IEEE 802.1p mapping click the DSCP Setting link in the DiffServ screen to display the
screen as shown next.
Chapter 43 Differentiated Services
DESCRIPTION
Select this option to enable DiffServ on the Switch.
This field displays the index number of a port on the Switch.
Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first to set the
common settings and then make adjustments on a port-by-port basis.
Changes in this row are copied to all the ports as soon as you make them.
Select Active to enable Diffserv on the port.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
0 – 7
8 – 15
16 – 23
0
1
2
GS2220 Series User's Guide
24 – 31
32 – 39
40 – 47
3
4
5
368
48 – 55
56 – 63
6
7
Advertisement
Table of Contents
Troubleshooting
