Table of Contents
Advertisement
Fig ure 279
The following table describes the labels in this screen.
Table 186 IP Application > DiffServ
L ABEL
Active
Port
*
Active
Apply
Cancel
43.3 DSC P- to - IEEE 802.1p Prio rity Se tting s
You can configure the DSCP to IEEE 802.1p mapping to allow the Switch to prioritize all traffic based on
the incoming DSCP value according to the DiffServ to IEEE 802.1p mapping table.
The following table shows the default DSCP-to-IEEE 802.1p mapping.
Table 187 Default DSCP-IEEE 802.1p Mapping
DSCP VALUE
IEEE 802.1p
43.3.1 C o nfig uring DSC P Se tting s
To change the DSCP-IEEE 802.1p mapping click the
screen as shown next.
Chapter 43 Differentiated Services
IP Application > DiffServ
DESC RIPT IO N
Select this option to enable DiffServ on the Switch.
This field displays the index number of a port on the Switch.
Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first to set the
common settings and then make adjustments on a port-by-port basis.
Changes in this row are copied to all the ports as soon as you make them.
Select
to enable Diffserv on the port.
Ac tive
Click
to save your changes to the Switch's run-time memory. The Switch loses these
Apply
changes if it is turned off or loses power, so use the
your changes to the non-volatile memory when you are done configuring.
Click
to begin configuring this screen afresh.
C a nc e l
0 – 7
8 – 15
0
1
GS2220 Series User's Guide
16 – 23
24 – 31
32 – 39
2
3
4
DSC P Se tting
368
link on the top navigation panel to save
Sa ve
40 – 47
48 – 55
5
6
link in the
screen to display the
DiffSe rv
56 – 63
7
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
