Introduction
This chapter describes the steps required for configuring the LCS60 software. An
example of a network topology is shown in Figure 3-1.
Figure 3-1: Example Network
LCS60
Mac
Lucent Data Switch
}
Modem Pool
Mac
LCS60
Mac
78:1FC (IPX)
Remote Access Clients
LAN
Note: Refer to Chapters 4, 5, 6, and 7 for examples of
PPP, SLIP, ARAP and gateway configurations.
LCS200
Router
All addresses and names in this figure are examples only.
Note:
Preliminary Hardware Requirements
Before configuring your LCS60, make sure you have followed the instructions in
Chapter 2 for hardware installation.
Issue 3
3-1