Figure 4-2: Configuring Ppp Service For Ip, Ipx, And Appletalk - HP LCS60 Installation Manual

LCS60 Configuration and Connection for PPP Service
Note: The user should familiarize him/herself with all aspects of the LCS60
PPP service. For details, including a description of Multiple IP Subnet-
works, refer to Chapter 1.
After configuring the LCS60 as described under Initial Setup in Chapter 3, per-
form the steps shown in Figure 4-2 to configure the LCS60 PPP Service.

Figure 4-2: Configuring PPP Service for IP, IPX, and AppleTalk

For TCP/IP
obtain virtual
IP address
For IPX
obtain virtual
network number
1 . Obtain the Ethernet IP address for the LCS60 and an IP network address
for each IP network security group. At least one IP address, in addition to
the Ethernet address, is required for SLIP and PPP service in order to
configure the physical connection used for SLIP/PPP. These IP network
addresses must be different from the LCS60's Ethernet internet address.
2 . If you will be using AppleTalk, obtain the AppleTalk virtual network
number and zone name. The network number and zone must be different
from the LCS60 AppleTalk Network and zone via the Ethernet.
3 . If you will be using IPX, obtain the IPX virtual network number, Ethernet
frame type, and Ethernet network number. The virtual network number
must be different from the LCS60 IPX network via the Ethernet.
4-2
config protocol
tcpip, atalk
ppp, ipx
maxsessions
For AppleTalk
obtain virtual
network number
and Zone name
srvsetup
configure client
side of PPP
service
ipas
atalkas
ipx
etherif
start all
Issue 3