HP LCS60 Installation Manual page 258

Processor Diagnostics - MVME197
DP Display Pass Count
ECDM ECDM Tests (DIR)
HE Help on Tests/Commands
HEX Help Extended
LA Loop Always Mode
LANC LAN Coprocessor (Intel 82596) Tests (DIR)
LC Loop Continuous Mode
LE Loop on Error Mode
LF Line Feed Mode
LN Loop Non-Verbose Mode
MASK Self Test Mask
NCR NCR 53C710 SCSI I/O Processor Test (DIR)
NV Non-Verbose Mode
PCC2 PCCchip2 Tests (DIR)
RAM Random Access Memory Tests (DIR)
RAMCD Generic Memory Tests with Data Cache only (DIR)
RAMCDI Generic Memory Tests with Instruction/Data Cache (DIR)
RTC MK48T0x Timekeeping (DIR)
SE Stop on Error Mode
ST Self Test (DIR)
ST2401 CD2401 Serial Self-Tests (DIR)
VME2 VME2Chip2 Tests (DIR)
ZE Zero Errors
ZP Zero Pass Count
Use the st command at the 197-Diag prompt to run the self-test firmware
diagnostics. This will list all tests and status (e.g., PASSED) as it runs. A partial
example is shown below:
197-Diag> st
ECDM REGS: Register Checks...................... Running --->
ECDM CHKGEN: Checkbit Generation................ Running --->
ECDM CHKRAM: Checkbit DRAM Test................. Running --->
ECDM SBEC: SBE Control Options.................. Running --->
ECDM SBEP: SBE Permutations..................... Running --->
ECDM DBEC: DBE Control Options.................. Running --->
ECDM DBEP: DBE Permutations..................... Running --->
ECDM INITCK: INIT Function Check................ Running --->
ECDM I2C: I2C Bus Interface Check............... Running --->
BSW REGS: Register Checks...................... Running --->
BSW TMR1A: Timer 1 Counter..................... Running --->
Use the sd command to return to the debugger prompt and then reboot as
shown:
9-24
PASSED
PASSED
PASSED
PASSED
BYPASS
PASSED
BYPASS
PASSED
PASSED
PASSED
PASSED
Issue 3