HP LCS60 Installation Manual page 381

6 . To set the IP address, under Configure, select TCP/IP (Figure F-7) and
enter the IP address in "Local IP Address."
Note: If you are using a privately administered IP address, enter it in the
Local IP Address field, otherwise the LCS60 will dynamically
assign an IP address (if a negotiable IP address has been admin-
istered in the client software package).
7 . From the Main Screen, Figure F-8:
Enter the phone number or the dialstring.
—
Under File, select Save As to save the setup to a file name (for
—
example, lcs60). This will allow you to launch lcs60 the next time
you want to establish the PPP connection, rather than repeating
this procedure.
8 . Select Connect from the main screen (Figure F-8) to make the connection.
The status will be displayed on the right side of the main screen as
Note:
shown in Figure F-8.
9 . To check AppleTalk status, select AppleTalk under Configure. This will
display a screen similar to that shown in Figure F-9.
Note: For additional status, under Status select:
Status for overall status of the connection
—
— Activity Log to see log entries of the connection.
Issue 3
PPP Service Examples
F-15