Config Directory Commands - HP LCS60 Installation Manual

lcsadm Interface
Description This command is used to change the log level of each
protocol server for a service. The higher the number given
for the log level, the more detailed the log file. Valid log
levels are:
arap
slip
atmgr
lcm
Default is shown in bold italic typeface.
Use the atlog command to set/display the atmgr log level.
Use the Manager directory log command to set/display the lcm log
level.
Name show
Synopsis show [service-type]
Description This command gives information about the specified ser-
vice type. Entering show without arguments will display
statistics for all services.
Example An example of the show command is given in the section
Typical Administrative Tasks later in this chapter.
Name types
Synopsis types
Description The types command lists the available service types.

Config Directory Commands

The Config directory (Screen 8-7) provides access to the configuration commands
(see Chapter 3) as well as a variety of administrative and maintenance com-
mands.
8-16
3, 6, 9 ppp
3, 6 asytcp
3, 9 tcpasy
3, 6, 20
3, 6, 9, 10
3, 6, 20
3, 6, 20
Issue 3