Table of Contents
Advertisement
14 . For the both Fujitsu and Seagate ST5660N drives: Continue with the dialo-
gue as shown in the screen below:
Please enter the 'node name' to call this machine, it must be
8 or less alphanumeric characters: ( unix ) morse
You can enter the value of the IP address now if you know it,
otherwise you can just press RETURN to continue.
If you do not enter a value now, the IP address must be initialized
later using the instructions found in the Initial System Setup booklet
in order to use the Internet functionality.
Internet Address: (
)
Enter the name of the OLD spooling directory;
just press <return> if this is a new installation: ( /usr/spool/lp )
Should the disable/enable commands be available to ALL users?[ y n ]( n )
Will you be attaching a PostScript printer to this system? [ y n ] ( y )
Enter the number of pseudo-terminal devices
to configure on your system [ 0-1024 ] ( 256 )
At this point, the installation should continue without interruption
until finished. You will only need to check occasionally for error
messages which require a response. If the installation media contains
multiple tapes, you may be asked to insert them as necessary.
1) Continue with Unattended Portion of Installation
2) Review Package Questions and Answers
Enter option number of choice: [ 1-2 ] ( 1 ) 1
The following disks will now be formatted:
m197_c0d0
You can safely ignore error messages such as:
Non-Motorola volume id read on unit xx
or
Invalid VTOC read on unit xx
Press <RETURN> to continue with formatting or interrupt (CTRL-c) to abort:
Issue 3
bnu Package Query #1
inet Package Query #1
Return
lp Package Query #1
lp Package Query #2
lp Package Query #3
nsu Package Query #1
Return
Ready to Start Installation
Ready to begin Formatting
Slicing Installation Disk(s)
Activating Swapping To Disk
UNIX System Software Installation
Return
Return
Return
Return
D-7
Advertisement
Chapters
Table of Contents
