Table of Contents
Advertisement
Introduction
This Appendix provides examples of software packages that may be used with
the LCS60. This Appendix is by no means comprehensive.
In order to configure your client software for use with the LCS60 for ARAP, PPP,
and/or SLIP service, you must refer to the documentation provided with that
software. This Appendix offers examples only.
Inclusion of various software packages in this Appendix is not an endorsement of
any of these products. If you encounter difficulty with your client software con-
figuration, contact the manufacturer of the client software. Lucent Technologies
provides support for the LCS60 side of the configuration only.
Client Software Configuration
To use the LCS60 as a server for ARAP, PPP, or SLIP service, the remote user
must have client software loaded on his or her PC or Macintosh that conforms to
the ARAP, PPP, or SLIP protocol specifications. These client packages provide
scripts that can be tailored by the remote user to guide him or her through dial-
ing the modem, NAC authentication (if applicable), and dialing the LCS60 for
remote access service. For information on configuring your client package, refer
to the documentation for that software.
To configure your software to use the LCS60 as the server:
Set up the connection to ARAP, PPP, or SLIP to send the following:
All users:
—
Destination [refer to the Service Connection Dialstrings section of the
appropriate chapter for PPP (Chapter 4), SLIP (Chapter 5), or
ARAP (Chapter 6)].
Issue 3
F-1
Advertisement
Chapters
Table of Contents
