Table of Contents
Advertisement
Description
This command generates a menu which allows you to
display and configure the software key parameters for
your LCS60. softwarekey is invoked by the initsetup pro-
gram since a key is required to activate any services you
configure for the LCS60. You must obtain a software key
from 1-800-WE2CARE for your particular LCS60 before
you can complete the softwarekey command. An example
of the softwarekey command is shown below.
The software key is specific to the release of the LCS60 and
will not grant access to features introduced in later
releases.
Top>Config># softwarekey
SOFTWARE KEY CONFIGURATION PARAMETERS
1. Display LCS60 Machine ID
2. Enter Software Certificate and Software Key
3. Display Software Certificate and Software Key
Enter Menu Selection
[ Type q to QUIT or ? for HELP ]
==> 1
+-------------------------+
|
|
|
+-------------------------+
SOFTWARE KEY CONFIGURATION PARAMETERS
1. Display LCS60 Machine ID
2. Enter Software Certificate and Software Key
3. Display Software Certificate and Software Key
Enter Menu Selection
[ Type q to quit or ? for help ]
==> 2
A valid LCS60 registration record has been found on your system.
Do you wish to retain the existing Software Certificate Number and Software
Key values?
Issue 3
|
LCS60 ID:
XXXXXXXX
|
|
lcsadm Interface
8-19
Advertisement
Chapters
Table of Contents
