Removing The Lcs60 Application Software - HP LCS60 Installation Manual

the LCS60 and the individual protocols and/or services you want to be up
whenever the system is rebooted.
Before you run "lcsadm" you should read about LCS60 configuration in the "LCS60
Network Interface Installation and Administration Guide" and assemble the
information required for configuration.
The system is ready.
morse
Console Login:
After the screen above is displayed, complete the installation by:
1 . Logging on as root
Note: As shipped, the root password is the
root password as soon as you log on.
2 . Accessing the lcsadm Interface
3 . Running initsetup and srvsetup (as required) as described in Chapter 3.

Removing the LCS60 Application Software

Before removing the LCS60 application software stop the configured protocols
and services by entering lcsadm -c stop all from the root prompt. Remove the
LCS60 application software by conducting the dialogue (as root; from the Con-
sole login) shown in Screen 9-5.
Issue 3
Reload System Software
key. Change the
Return
9-13