Table of Contents
Advertisement
Administration
R3.0 Upgrade
Previous releases of the LCS60 can be upgraded to Release 3.0. This requires
removing the software and any patches for the earlier release and installing the
R3.0 software from tape. Upgrade procedures are given in Chapter 9.
The configuration is automatically restored after installing R3.0; the user need
only configure new or changed services.
Note:
When upgrading from R1.0 or R2.0 to R3.0, you must have an R3.0
software key to activate R3.0 features. Refer to the section on Copy Pro-
tection.
Remote Upgrade
Upgrading multiple LCS60s to release 3.0 or greater can be done using the
remote upgrade feature. To upgrade several LCS60s to release 3.0 or greater, the
local tape drive need only be used to install the upgrade release on a single
LCS60 (the remote upgrade server). All other R2.0 or greater LCS60s in your
data switch network (remote upgrade clients) may then be upgraded remotely
across the data switch network.
Centralized Network Management
StarKeeper II NMS provides complete network management from one central-
ized location for both the data switch and the LCS60. The StarKeeper II NMS can
be located anywhere on the data switch network and can contact many LCS60
gateways.
1-20
Issue 3
Advertisement
Chapters
Table of Contents
