Figure 5-2: Configuring Slip Service - HP LCS60 Installation Manual

LCS60 Configuration and Connection for SLIP Service

Figure 5-2: Configuring SLIP Service

obtain IP
address
1 . Obtain the Ethernet IP address for the LCS60 and obtain an IP network
address for each IP network security group. At least one IP address, in
addition to the Ethernet address, is required for SLIP and PPP service in
order to configure the physical connection used for SLIP/PPP. These IP
network addresses must be different from the LCS60's Ethernet internet
address.
2 . Enter the lcsadm interface.
3 . Add the SLIP service:
From Config , enter protocol, or config protocol from Top .
Add tcpip (as required).
Add slip.
4 . Define the SLIP service sessions (maxsessions):
From the Config directory, enter max, or enter config maxsessions
at the Top directory.
5-2
config protocol
maxsessions
tcpip slip
ipas
srvsetup
configure client
side of SLIP
service
etherif
start all
Issue 3