Emi Considerations; Required Equipment; Table 2-3: Required Additional Equipment - HP LCS60 Installation Manual

EMI Considerations

The LCS60 can radiate radio frequency energy, and if not installed in accordance
with instructions, may cause interference to radio communications. This equip-
ment has been tested and found to comply with the limits for a Class A comput-
ing device pursuant to Part 15, Subpart J of FCC Regulations, which are designed
to provide reasonable protection against such interference when operating in a
commercial environment. Operation in a residential area is likely to cause
interference, in which case the user must take whatever measures may be
required to correct the interference.

Required Equipment

The LCS60 is shipped in the hardware configuration ordered, the operating
software loaded, and user documentation included. Additional equipment
required for the initial installation of an LCS60 is listed in Table 2-3.

Table 2-3: Required Additional Equipment

Quantity Item
1 Fiber Pair
1 RS-232
(DB25) Cable
1 Ethernet Transceiver
(IEEE Cable)
(as reqd.) Horizontal Shelf,
Slide Rails, or
support brackets
1 (as reqd.) ED5P183-33, G-40
1 CPM-HS module
1 AWJ2
(as reqd.) wire
*
Formerly AT&T FL2P-P.
Issue 3
Description
Lucent FL2P-P-[length]* (specified in feet)
Length required to connect console to
LCS60
Length required for connection from
LCS60 to Ethernet transceiver
Rack mounting hardware for additional
support; provided by rack/cabinet
vendor.
Wall Mounting Kit for LCS60
Node connection
Paddleboard for the CPM-HS module
18 AWG — 6 AWG wire for DC powered unit only
Site Preparation
2-5