Lcs60 Configuration And Connection For Ppp Service; Figure 4-1: Example Network - Ppp Service - HP LCS60 Installation Manual

LCS60 Configuration and Connection for PPP
Service
Figure 4-1 shows an example network using PPP service.
Note: PPP service using AppleTalk requires an R2.0 or R3.0 software key. IPX
service requires an R3.0 software key. Refer to Chapter 3 for information
about the software key.
Figure 4-1: Example Network – PPP Service
LCS60
LAN
Apple Printer
Novell File Server
Workstation
You can configure the LCS60 for PPP service using either the srvsetup command
or the individual commands (protocol, maxsessions, ipas, ipx, atalkas, etherif).
The examples in this chapter use the individual commands.
If previous configuration (for example, for SLIP service) was performed, some of
the steps required for configuring the LCS60 for PPP service may have already
been completed (e.g., etherif, ipas). Skip the steps that have been completed pre-
viously.
Issue 3
Mac
Lucent Data Switch
Modem Pool
Mac
Remote Access Clients
4-1