HP LCS60 Installation Manual page 251

2 . Access the Remote Upgrade Installation Menu using lcsadm -c config
upgrade or:
# lcsadm
Top># config
Top>Config># upgrade
CLIENT Procedures:
1. Enable a client to receive a generic download
2. Remove from client the previously installed generic
3. Install on a client the downloaded generic
4. Disable a client from receiving a generic download
..............................................................
SERVER Procedures:
5. Copy (from Tape) a generic onto this server
6. Send a generic from this server to a client
7. Remove a spooled generic from this server
Enter Menu Selection
[ Type q to QUIT or ? for HELP ]
==>
3 . You are on the client. Select item 1 and enter the server's call address in the
form area/exchange/local when prompted. This authorizes the server to
establish the necessary connections.
Note: Do not exit or quit at this time. You will need to perform some
additional steps later on throughout this procedure.
4 . Log on to the server from the system console as root.
5 . Access the Remote Upgrade Installation Menu using lcsadm -c config
upgrade.
5 . On the server; select item 5 under the SERVER Procedures and answer
the prompts accordingly.
Note: A server can only maintain (i.e., spool) one copy of an LCS60
software generic and an LCS60 patch. Therefore, if a copy already
resides on the server, this procedure will automatically remove it
before copying the newer generic from tape onto disk.
Issue 3
REMOTE UPGRADE INSTALLATION MENU
Remote Upgrade
9-17