Figure F-4: Pc/Tcp Session Configuration Screen Example - HP LCS60 Installation Manual

Figure F-4: PC/TCP Session Configuration Screen Example

COM2
154.12.22.81
Set the port and baud rate to the ones you are using with your modem. Enable
hardware flow control.
To have the LCS60 assign your client software an IP address dynamically, leave
the IP address as zeroes and add the -D option to your data switch dialstring. For
a privately administered address, enter the IP address your LCS60 administrator
assigned to your client software. To request your reserved IP address, leave the
IP address as zeroes and omit the -D dialstring option. Leave the login and pass-
word fields blank; the client software will not be using PPP authentication, but
the NAC instead (by means of the dialup script.) Leave the VJ settings as the
defaults.
Note: Negotiation of the TCP/IP header compression option is defined in
RFC1332. If your client package supports Van Jacobson Header
Compression, then configure this feature on your Mac or PC. The size of
each packet can shrink up to 35 bytes, thereby giving your PPP session a
significant performance boost.
Activate the dialup script by selecting
progresses, a Progress Monitor screen will show dialup script activity to the
LCS60. Once the
IPCP
Issue 3
14400
Start Script .
is highlighted, the PPP connection is established.
PPP Service Examples
As the connection
F-13