Table of Contents
Advertisement
8 . The next field is optional. At Location enter the location of the LCS60
entered in Step 5 (e.g., room number) followed by a
Return .
9 . At Time zone enter the applicable time zone for the LCS60 entered in Step 5
followed by a
Return
format details).
10 . The next field is optional. At Comment enter a comment (or nothing) and
press
Ctrl-g .
11 . At Console press
12 . At Alarms enter y
connection.
13 . At Status enter
a
II NMS to begin monitoring this LCS60.
If you are not ready for StarKeeper II NMS to begin monitoring this
LCS60 (for example, you are populating the database in anticipation of
deploying an LCS60), enter i
14 . At Method enter
NMS should use its host fiber interface to monitor the LCS60.
15 . At Dial string enter the area/exchange/name of the LCS60 entered in Step 5
followed by a carriage return (e.g., mlkway/earth/morse
is, the data switch call address that StarKeeper II NMS should use to mon-
itor the LCS60.
16 . At Password enter
17 . At Host Number select the StarKeeper II NMS host interface number that
should be used to monitor the LCS60. Enter 0
18 . At StarKeeper II NMS name field, if the field is not already populated, enter
the name of the StarKeeper II NMS that will monitor this LCS60 and then
enter
Ctrl-g .
The StarKeeper II NMS should confirm the entry of the LCS60 with Alarms
connection has been added.
19 . Press
(6386) or
Delete
tem. At the CONFIRM EXIT prompt, enter
selection menu.
Issue 3
Configuration of the StarKeeper II NMS
(refer to the StarKeeper II NMS documentation for
Return .
to indicate that the LCS60 uses an Alarms-type
Ctrl-t
followed by
Return
Return .
followed by
h
Return
to use the default password.
Return
(HP) three times to exit the menu sys-
Break
or just enter
Return
if you are ready for StarKeeper
to indicate that StarKeeper II
Return ),
Return .
to return to the main
Return
that
B-5
Advertisement
Chapters
Table of Contents
