Parameters; Appletalk Network/Zone (Atalkas) - HP LCS60 Installation Manual

RIP Routing information protocol. A configurable lcsadm process
for routing IP packets.
RFC Request for comments document of the IETF.
routed A service which uses RIP to maintain the IP route table. A confi-
gurable lcsadm process for routing IP packets.
router A device that routes information between networks.
SLIP Serial Line IP Protocol. An internet protocol.
SNMP Simple Network Management Protocol.
socket ser- This service is used to allow LAN connected hosts to initiate
vice uucp connections to data switch connected hosts. The LCS60
terminates the uucp TCP datastream and retransmits it using 8-
bit virtual circuits over the data switch network to remote asyn-
chronous endpoints.
subnetwork In TCP/IP Protocol, a logical subsection of a single internet net-
work (e.g., dock-net is divided into subnets m-net0 and b-net).
telnet service The telnet service provides telnet network virtual terminal emu-
lation to a data-switch connected device.
zone A collection of networks on an AppleTalk internet. AppleTalk
uses zones to group resources logically across LANs, indepen-
dent of device location; that is, zones do not have to be physi-
cally contiguous. Zones allow users to find devices easily.

Parameters

The following parameters are used in configuring the LCS60. The parameters are
listed alphabetically according to the service being configured.

AppleTalk Network/Zone (atalkas)

network This is a number between 1 and 65279. It must not be equal to any
number other network number in use in the AppleTalk network, and must
not be contained within any other network number range in use in
the AppleTalk network.
Issue 3
Glossary
G-3