Table of Contents
Advertisement
Configure Default Route, DNS, and SNMP
Default Route – dftroute*
Use the dftroute command to define the default route as shown in the example
below.
The default route may be entered either as a host name or as a TCP/IP dotted
numerical address (e.g., holmes or 154.12.21.3). The host name entered as the
default router must exist in the LCS60 configuration database; use the addhost
command to add the host as necessary.
Top>Config># dftroute
CURRENT default route is . . . . . . .
DEFAULT ROUTE FUNCTIONS
====================================================
1 ... Define the default route
2 ... Delete the default route
To select a function, enter the corresponding number
[ Type q to quit or ? for help]
==>
1
CAUTION:
The default route defined here will be overridden if a
router is advertising a default route in the network.
Enter default router (name, alias, or internet address)
[ Type q to quit or ? for help ]
==>
154.12.21.3
Trying to reach host "154.12.21.3" ... OK.
CURRENT default route is ....... None
NEW
default route will be .. 154.12.21.3
Enter y to confirm NEW default route "154.12.21.3"
Enter n to reject
==>
y
Top>Config> #
Be sure to specify routed with the protocol command to start default route ser-
vice at boot time.
*
The dftroute command cannot be run unless the TCP/IP protocol is running.
3-24
None
NEW default route "154.12.21.3"
Issue 3
Advertisement
Chapters
Table of Contents
