HP LCS60 Installation Manual page 90

Configure Protocols and Gateway Services — srvsetup
Enter Menu Selection
[? for help, q to quit, RETURN for menu]
==> q
*** This step allows the LCS60 Administrator to define the maximum number of
*** sessions for each configured service.
CAUTION: Please refer to the I&A Guide for instructions
about configuring this feature.
LCS60 AND SERVICE SESSION PARAMETER CONFIGURATION MENU
1. Add/Change a Session Parameter
2. Delete a Session Parameter
3. Display all Session Parameters
Enter Menu Selection
[ Type q to QUIT or ? for HELP ]
==> 1
Enter session parameter:
"maxsessions", "ppp", "slip", "arap", "asytcp", "tcpasy"
[ Type q to QUIT or ? for HELP ]
==> tcpasy
Note: If you enter a value greater than 180 for maxsessions, the CPM-HS
module must be configured for 512 channels (refer to page 2-25).
Enter session parameter value
[ Type q to QUIT or ? for HELP ]
==> 120
NOTICE: Entering < tcpasy > service with value of < 120 >
Is this correct?
Enter y,n ==> y
CAUTION: Please refer to the I&A Guide for instructions
about configuring this feature.
LCS60 AND SERVICE SESSION PARAMETER CONFIGURATION MENU
1. Add/Change a Session Parameter
2. Delete a Session Parameter
3. Display all Session Parameters
3-12 Issue 3