HP LCS60 Installation Manual page 84

Initial Setup
Top># config
Top>Config># Return
Commands may be abbreviated.
addhost addnet
datetime delhost
etherif help
manager/ maxsessions
quit service/
srvports srvsetup
viewhosts viewnets
Top>Config># init
Enter init (at Top Config ) to start the initsetup routine.
Step 10
Step 11 Follow the menus in the initsetup; they will guide you through the
essential items that must be configured for basic LCS60 operation (as
shown in Figure 3-2). A sample initsetup session is presented on the
following screen.
Top>Config># init
LCS60 Initial Setup and Configuration Procedure
The "initsetup" procedure leads you through the steps to initially set up this
LCS60 by entering the node name, time and date, and the software key.
*** This step allows the LCS60 Administrator to set the node name.
*** This is the name by which other hosts know this LCS60.
The LCS60 is currently called "sysV68".
==> Do you want to change it? [y, n, ?, q] y
Enter the new node name for this LCS60
[? for help, q to quit]
==> morse
*** This step allows the LCS60 Administrator to set the timezone, date, and
*** time of the LCS60 system clock.
Current time and time zone is: 13:33 EST
==> Change the time zone? [y, n, ?, q] n
Current date and time: Mon. 08/17/95 13:33
==> Change the date and time? [y, n, ?, q] n
3-6
Commands are:
atalkas backup
delnet dftroute
initsetup ipas
nodename ports/
session/ snmp
subnet top/
^ !
console
dns
ipx
protocol
softwarekey
upgrade
Issue 3