Configure Protocols And Gateway Services Srvsetup; Figure 3-3: Srvsetup - HP LCS60 Installation Manual

Configure Protocols and Gateway Services —
srvsetup
After executing the initial setup procedures above, configure the protocols and
gateway services using the srvsetup command (Figure 3-3).

Figure 3-3: srvsetup

srvsetup configure protocols/services
ipx ipas
Note: The configuration activities in the srvsetup command (protocol,
maxsessions, ipas, ipx, atalkas, etherif) can also be accessed
individually. Refer to Chapters 4, 5, 6, and 7 for examples of individual
commands.
Perform the following steps to configure the protocols and gateway services for
your LCS60. (You should have already done an initsetup as described
previously.)
Step 1 Enter srvsetup at the Top Config # prompt to start the
protocol/service setup routine.
Step 2 Follow the menus in the srvsetup; they will guide you through the
items essential for your configuration (refer to Figure 3-3). A sample
srvsetup session is presented in the screens that follow.
Note: Refer to the Glossary at the end of this document for definitions of
parameter values.
3-10
select protocols and services:
protocol
asytcp, tcpasy, etc.
assign the maximum
maxsessions
number of sessions to
each protocol and service
atalkas
etherif
configure the ethernet
interface
Issue 3