Table 3-1: Protocol And Services Commands - HP LCS60 Installation Manual

Note: You must have the appropriate key to activate the features on your
LCS60. The R1 key will activate gateway services and the IP protocol
feature, R2 activates the R1 features and the AppleTalk protocol feature,
and the R3 key will activate all R2 features and the IPX protocol.
After completing the steps in initsetup, you must complete the configuration of
your LCS60 by adding the protocols and services you will be using. Refer to the
sections (Configure Protocols and Gateway Services– srvsetup and Configure Default
Route, DNS, and SNMP ) below to complete the configuration of your LCS60.
The individual configuration commands are listed in Table 3-1. These com-
mands may be run individually from the Top Config prompt, or as part of the
srvsetup command as noted in Table 3-1.

Table 3-1: Protocol and Services Commands

Service
Define protocols/services
Configure the Ethernet Interface
Set the default route
Configure the Domain Name Resolver
Configure the SNMP Agent
Define the maximum LCS60
and gateway service sessions
Configure IPX virtual and ethernet addresses
for PPP sessions
Configure virtual network for SLIP
and PPP services
Configure virtual AppleTalk
network/zone for PPP and ARAP services
Configure TCP-to-Async gateway service (ports)
Issue 3
Initial Setup
Command Notes
protocol srvsetup
etherif srvsetup
dftroute dftroute
dns dns
snmp snmp
maxsessions srvsetup
ipx srvsetup, Chap. 4
srvsetup,
ipas Chap. 4 and 5
atalkas srvsetup,
Chap. 4 and 6
srvports Chap. 7
3-9