Dialogues; Enter Group Name; Define The Local Address For The Lcs60 - HP LCS60 Installation Manual

Installing the LCS60

Dialogues

Note: Dialogues differ depending on the data switch and release.

Enter Group Name

CC0> enter group
GROUP [up to 8 chars]: morse
TYPE [local, trunk: +(local)]: local
DIRECTION [originate, receive, 2way]: 2way
DEVICE OR HOST [up to 8 chars]: morse
PASSWORD [up to 8 chars, none: +(none)]:none
ROUND ROBIN SERVICE [per_port, per_module, none: +(none)]: none
GROUP [up to 8 chars]:
CC0>
Conduct the appropriate dialogue as shown in screen above. (Enter
end the session.) The entries are described below:
group Defines the group name by which the data switch knows the
LCS60. This is morse in the example. This must be the same as
the LCS60 node name.
type The LCS60 is a local connection to the data switch (the CPM-HS
module resides in this data switch).
direction The fiber interface may be used to originate and receive calls
through the CPM-HS module, therefore, it is 2way.
device/host We recommend the name be the same as the name of the LCS60.
password Passwords are not used with the CPM-HS module.
round robin Choose the default of none.

Define the Local Address for the LCS60

Note: You must enter an address for each IP Network Security group on the
node with a group name of the default node.
Conduct the appropriate dialogue as shown in the screen below.
2-22
Delete
to
Delete
Issue 3