Screen 4-4: Configure Appletalk Virtual Network – Example - HP LCS60 Installation Manual

LCS60 Configuration and Connection for PPP Service
[ ? for help, q to quit, RETURN for menu ]
==> q
NOTICE: To allow IPX configuration changes to take effect you must first stop
and restart the IPX software as follows:
lcsadm -c stop ipx
lcsadm -c start ipx
10 . Configure the AppleTalk network/zone (atalkas):
Enter atalkas at the Top Config # prompt or enter config atalkas
from the Top directory.
Follow the on-screen instructions for setting up the AppleTalk
network number and zone name. (Refer to Screen 4-4.) The virtual
AppleTalk address must be defined; it is used for dynamic
allocation of AppleTalk addresses for PPP and ARAP clients.
Screen 4-4: Configure AppleTalk Virtual Network – Example
Top>Config># atalkas
CONFIGURE ADDRESS AND ZONE FOR APPLETALK VIRTUAL NETWORK
1 Configure Address and Zone Name
2 Display Address and Zone Name
3 Delete Address and Zone Name
Enter Menu Selection
[ Type q to quit or ? for help ]
==> 1
*** The AppleTalk virtual network has not yet been configured.
Enter the network number for the LCS60 interface to the AppleTalk network.
This must be a number between 1 and 65279, and must NOT be equal to any
other network number in use in the AppleTalk network, and must not be
contained within any other network number range in use in the AppleTalk
network.
[ Type q to quit ]
==> 2010
4-10
Screen 4-4: continued on next page
Issue 3