Configure The Cpm-Hs Module - HP LCS60 Installation Manual

Installing the LCS60
address This is the IP network security group name. The first address
entered must be the the same as the node name that is
assigned to the LCS60 when the LCS60, itself, is subsequently
configured from the LCS60's system console. Up to four
security groups may be configured for the LCS60, therefore,
four corresponding local addresses may be defined.
PAD This is not used.
directory entry A 30-character description of the LCS60 in double quotes.
group Enter the group from the previous operation.
security pattern The originating group name security feature allows the
Datakit II VCS to restrict calls for this host to a select group of
Datakit II VCS originating groups. Since the srvtab files (see
Appendix A) may also be used to restrict incoming calls,
Return
service state The local address must be in service for the LCS60 to originate
and receive calls.

Configure the CPM-HS Module

CC0> enter cpm
MODULE ADDRESS: 6
COMMENT [up to 60 chars double quoted]:
"fiber interface to LCS60"
HARDWARE TYPE [422, hs: +(hs)]: hs
NUMBER OF CHANNELS [2-512: +(32)]:512
CONNECT-TIME BILLING [on, off: +(off)]: off
SINGLE OR MULTIPLE GROUP(S) [single, multiple: +(single)]: single
GROUP [up to 8 chars]: morse
ENDPOINT NUMBER OR RANGE [0000-9999, none: +(none)]: none
CC0> restore cpm 6
CC0>
Conduct the dialogue as shown in the screen above.
address
2-24
is used to disable this feature.
Check the data switch cabinet for the slot number of the
CPM-HS module to which the LCS60 is connected.
Enter the slot number of the CPM-HS module. In this
example the CPM-HS module is in slot 6.
Issue 3