HP LCS60 Installation Manual page 165

From the Config directory, enter max, or enter config maxsessions
at the Top directory.
Assign the number of sessions of each type for the gateway service:
tcpasy and asytcp. The total number of sessions for all services is
120 if PPP, SLIP, or ARAP is configured. If these services are not
configured, the total number of sessions is 500.
4 . Configure TCP-to-asynchronous gateway service ports (srvports):
Up to 500 TCP service ports can be configured if the LCS60 is used
Note:
for gateway service only. The ports are identified by a number
and can be customized with pre-defined destinations (PDDs),
disconnect options, inactivity timers, and other options. For a
complete description of all of the parameters, refer to the
Glossary.
Enter srvports at the Top Config # prompt or enter config srvports
at the Top directory.
Select 2 (Add a service port).
Enter a number in the range 1024 – 65535.
Assign a type of service to the port: telnet for remote terminal
access, socket for 8-bit (raw) TCP data stream (e.g., uucp file
transfer), or directory for LAN queries of the TCP service port
database.
Follow the on-screen instructions for customizing each service port
you are configuring. Help is available by typing ?. A sample
session (illustrating each of the three service port types) is shown in
Screen 7-1.
5 . If TCP/IP has not been started enter start tcpip from the Top directory
now.
Issue 3
LCS60 Configuration and Connection for Gateway Service
7-3