Ppp Service Connection Dialstrings - HP LCS60 Installation Manual

Screen 4-5:
Continued
[ ? for help, q to quit, RETURN for menu ]
==> q
NOTE: Changes to the configuration will not take effect until you:
- enter the lcsadm command and then type "stop tcpip" from the
top command directory to stop TCP/IP protocol.
- enter the lcsadm command and then type "start tcpip" from the
top command directory to start TCP/IP protocol.
Top>Config>#
12 . From the Top directory, enter start all.
Note: In order for changes made to the IP network number or subnet
mask to take effect, you must first stop and then restart tcpip and
routed.
13 . To complete PPP configuration, you must configure the client side of the
service. Refer to the documentation included with your client software;
examples of some software packages are given in Appendix F.
To unconfigure PPP service, stop the service using the stop ppp command, enter
maxsessions at the Top Config # prompt, and choose option 2 to delete the
service.

PPP Service Connection Dialstrings

One of the following types of dialstrings (shown with the area/exch/name from the
example in Figure 4-1) may be used to connect to the LCS60 for PPP service.
Issue 3
LCS60 Configuration and Connection for PPP Service
4-13