Table of Contents
Advertisement
Configuration of the StarKeeper II NMS
6 . Remove the floppy diskette or tape from the drive when installation is
complete.
7 . Enter exit
Return
8 . Re-start the StarKeeper II NMS:
a . At the SK: prompt, enter SKsh; this displays the main menu
b . Choose SYSADM ; this displays the sysadm menu
c . Choose STARTSK; select y to continue with startup. Enter
when you see the startup completed message.
Return
d . Exit the SKsh program by pressing
Exit the Menu Program? prompt.
9 . You can now configure the database to monitor individual LCS60s (see
below).
StarKeeper II NMS – Configuration Commands
After the software package has been installed, the network administrator can
configure the StarKeeper II NMS's database to monitor individual LCS60s.
1 . Log on to StarKeeper II NMS as cnmsadm.
2 . At the SK: prompt, enter SKsh
menu. Select the "Configuration Commands" by entering c
displays the Network Elements menu.
3 . Select menu item System/Node by pressing
"Configure a System/Node" menu.
4 . Select menu item Add by pressing
5 . At System/Node name enter the name of the LCS60 (e.g., morse
the example in Figure 3-1).
6 . At Type enter L60
7 . At Release enter 3.0
B-4
to restore the user id to cnmsadm.
This displays the selection
Return .
Return .
Return .
Return .
and then y at the
Return
Return ;
This displays the
Return .
Return ,
Issue 3
this
in
Advertisement
Chapters
Table of Contents
