Interppp; Connection - HP LCS60 Installation Manual

PPP Service Examples
Note: Be aware that baud rates are dictated by the application, serial drivers
installed, and the version of the PC UART.

InterPPP

InterPPP II is different from InterPPP. Refer to the user documentation
Note:
for specific details.
The InterPPP software requires minimal Mac configuration for AppleTalk or IP
over PPP.
Note: Make sure MacTCP is installed in the Control Panels folder. MacTCP
should come with the InterPPP package. TCP/IP should be selected
under the MacTCP for the initial connection.
Note: Remember to reselect PPP for the next PPP session.

Connection

To establish the PPP connection, perform the following steps:
1 . From the Network Control Panel of the Control Panels folder select the
AppleTalk/PPP icon. (Refer to Figure F-5.) This tells the AppleTalk
software to use the serial port instead of the built in LAN port.
2 . Launch the InterPPP application.
3 . Under File, choose New or Open CCL Script; create/edit and save the
script.
4 . Under Configure, select Modem (refer to Figure F-6):
Choose Port; select Modem Port
—
— Choose Modem; select your CCL script
Choose After Connect: select StartPPP; then close the window.
—
5 . Under Configure; select PPP: choose the PPP settings (Figure F-6); then
close the window.
F-14 Issue 3