Log File; Related Commands - HP LCS60 Installation Manual

Log File

The log file, arap.log is written to by the LCS60 interface software and contains
information about incoming ARAP call requests. To display the contents of the
arap.log file, use the page command as shown in the example below:
# pg /usr/adm/lcs/arap.log
Fri Jun 2 15:41:04 23961
Fri Jun 2 15:41:04 23961
Tue Jun 20 13:15:55 2159
arap is temporarily disabled
Tue Jun 20 13:16:19 2188
Tue Jun 20 13:16:20 2188
Tue Jun 20 13:16:29 2188
uid=5126
Tue Jun 20 13:17:30 2188
Tue Jun 20 13:17:30 2188
Wed Jun 21 08:15:01 2188

Related Commands

The following commands may be of particular interest when administering the
LCS60's ARAP service:
The manual pages for these commands are contained in Appendix E of this docu-
ment; they are also available online.
Issue 3
[3] arap1 started loglevel = 3
[3] arap1 nfiles=256
[3] ARAPTOSS dk=mlkway/earth/topper.36.20 uid=5126 \
[3] arap1 started loglevel = 3
[3] arap1 nfiles=256
[3] arap1 NEW 1.1 dk=mlkway/earth/topper.36.20 ch=510 \
[3] arap1 1.1 Connect Failed, r=4
[3] arap1 DEL 1.1
[3] arap1 exited
atping atnetstat
Administration
atlog
6-7