Loading The Preprocessor Interface Software; To Load The Configuration And Inverse Assembler - HP E2470A Manual

Loading the Preprocessor Interface Software

The logic analyzer can be configured for MC68HC16Y1 analysis by
loading the appropriate configuration file. Loading the state file
automatically loads the inverse assembler file.

To load the configuration and inverse assembler

Make a duplicate copy of the master disk prior to setting up the
1
preprocessor interface.
Insert the HP E2470A disk in the front disk drive of the logic analyzer.
2
Depending on your logic analyzer, select one of the following menus:
3
•
For the HP 1660-series logic analyzers, select the "System Disk" menu
•
For the HP 16500A mainframe, select the "System Front Disk" menu
•
For the HP 16500B mainframe, select the "System Flexible Disk"
menu
Configure the menu to "Load" the analyzer configuration from disk.
4
Select the appropriate module (such as "100/500 MHz LA" or
5
"Analyzer") for the load.
Use the knob to select the appropriate configuration file.
6
Choosing the correct configuration file depends on which analyzer you are
using and whether you need timing or state analysis. The file names are
listed at the bottom of the illustrations showing the connections for your
particular logic analyzer.
Execute the load operation to load the file into the logic analyzer.
7
1–13