Table of Contents
Advertisement
4
4.2.2
Mounting on Duo-Pos stand
You can attach the Duo-Pos stand to the product at a 20° or 45° angle.
Mount the stand with the supplied M4 x 8 ISO 7380 hex screws to the lower
VESA 100 tapped holes on the rear panel of the product
Using the mounting slots (width = 4.5 mm), screw the stand to a supporting
surface
or
Attach self-adhesive rubber pads to the underside of the stand
Route the cable from behind through the two supports of the stand and then
through the lateral openings to the connections
Figure 4: Product mounted on Duo-Pos
stand
Further information:
36
Comply with the permissible tightening torque of 2.6 Nm
"Product dimensions with Duo-Pos stand", Page 297
Mounting | Assembly of the device
Figure 5: Cable routing on Duo-Pos stand
HEIDENHAIN | POSITIP 8013 ACTIVE | Operating Instructions | 01/2018
Advertisement
Table of Contents
