Table of Contents
Advertisement
Quick Start | Machining a rectangular pocket (MDI mode of operation)
9.5.2
Milling the rectangular pocket
The values for spindle speed, milling depth and feed rate depend on the
end mill's metal-removal rate and the machine tool.
HEIDENHAIN | POSITIP 8013 ACTIVE | Operating Instructions | 01/2018
To run the block, tap END
The positioning aid is displayed
If the simulation window is active, the rectangular pocket is
visualized
On the machine tool, insert the Ø 12 mm end mill into the
spindle
On the product, set the spindle speed to a suitable value
When you are using a machine tool with NC-controlled axes
and have enabled the POSITIP 8000 NC2 software option on
the product:
Press the NC START key on the machine tool
On the OEM bar: Tap Coolant ON
Follow the instructions of the wizard
Set the milling cutter to the desired milling depth
Start the machining – follow the instructions of the wizard
The product executes the individual steps of the milling
procedure
On the OEM bar: Tap Coolant OFF
Retract the spindle
Tap Close
Program run is terminated
The wizard closes
You have successfully machined the rectangular pocket
9
153
Advertisement
Table of Contents
