Table of Contents
Advertisement
9
9.7
Determining the preset (manual operation mode)
To align the bolt hole circle and frame of holes you must set the circle center of
the fit as the preset. Based on this preset the product then calculates all values for
the relative coordinate system. Ascertain the preset with the HEIDENHAINKT 130
Edge Finder.
Figure 32: Example workpiece – determining preset D2
Activation
Probing the preset
156
Quick Start | Determining the preset (manual operation mode)
D2: 0/0
Tap Manual operation in the main menu
The user interface for manual operation is displayed
On the machine tool, insert the HEIDENHAINKT 130 Edge
Finder into spindle and connect to the product
Further information:
"Configuring a touch probe", Page 102
Tap Probing on the status bar
The Probing dialog box opens
In the Probing dialog tap Circle center
The Select the tool dialog box opens
In the Select the tool dialog, activate the Use touch probe
option
Follow the instructions of the wizard
Move the edge finder toward the workpiece edge until the
red LED on the edge finder lights up
The Select preset dialog box opens
Retract the edge finder from the workpiece edge
In the Selected preset field, select preset 1
In the Set position values field, enter the value 0 for position
value X and position value Y and confirm with RET
Tap Confirm in the wizard
The probed coordinates are loaded in preset 1
HEIDENHAIN | POSITIP 8013 ACTIVE | Operating Instructions | 01/2018
Advertisement
Table of Contents
