Outputs (S) - HEIDENHAIN POSITIP 8013 ACTIVE Operating Instructions Manual

Settings | Axes

15.6.21 Outputs (S)

Settings ► Axes ► S ► Outputs
Path:
Parameters
Analog output
Analog output is inverted
Fmax
Umax
Enable spindle CW
Enable spindle CCW
HEIDENHAIN | POSITIP 8013 ACTIVE | Operating Instructions | 01/2018
Explanation
Assignment of the analog output according to pin layout
Default value: Not connected
If this function is active, the analog signal is inverted at the
output
Default value: not active
Definition of the Spindle speed achieved at Umax
Setting range: 100 rpm ... 10000 rpm
Default value: 2000
Maximum voltage that is output at the analog output in order to
achieve Fmax
Setting range: 1000 mV ... 10000 mV
Default value: 9000
Assignment of the digital output for the clockwise spindle enable
according to pin layout
Default value: Not connected
Assignment of the digital output for the counterclockwise
spindle enable according to pin layout
Default value: Not connected
15
263