Switching Functions - HEIDENHAIN POSITIP 8013 ACTIVE Operating Instructions Manual

7
Manufacturer-specific M functions
The product also supports manufacturer-specific M functions with the following
characteristics:
Number range definable from M100 to M120
Function depends on the machine manufacturer
Use in the button of the OEM bar
Further information:
7.3.4

Switching functions

Configuring a touch probe
You can use probing functions to set presets with a HEIDENHAIN KT 130 Edge
Finder. The stylus of the edge finder can be additionally fitted with a ruby ball tip.
In order to use the KT 130 edge finder, you need to configure the relevant
parameters. The parameters are taken into account by the probing functions.
102
The manufacturer-specific M functions M100 to M120 are only available
if the connected output has been previously configured.
Further information: "Configuring M functions", Page 251
"Configuring the OEM bar", Page 105
Tap Settings in the main menu
Tap Sensors
Tap Touch probe
Select the KT 130 model for edge detection in the Touch
probe drop-down list
Use the ON/OFF sliding switch to activate or deactivate the
Always use touch probe for probing option as needed
Enter the length difference of the edge finder into the Length
field
Confirm the entry with RET
Enter the stylus diameter of the edge finder into the
Diameter field
Confirm the entry with RET
Commissioning | Steps for commissioning
HEIDENHAIN | POSITIP 8013 ACTIVE | Operating Instructions | 01/2018