Block Types; Positioning - HEIDENHAIN POSITIP 8013 ACTIVE Operating Instructions Manual

Programming | Block types
13.2

Block types

You can use the following block types for programming:
Positioning functions
Change of coordinate system (preset)
Machine functions
Machining patterns
13.2.1

Positioning

You can manually define position values for positioning. Depending on the
configuration of the connected machine tool, you can then move the tool to these
positions either automatically or manually.
In the appropriate input fields you can load the current axis position with
Actual position capture.
The following parameters are available:
Positioning block
Parameter
R0
R+
R-
HEIDENHAIN | POSITIP 8013 ACTIVE | Operating Instructions | 01/2018
Description
Tool radius compensation disabled (default setting)
Positive tool radius compensation; the traverse path is
increased by the tool radius (outside contour)
Negative tool radius compensation; the traverse path is
decreased by the tool radius (inside contour)
Incremental position value, i.e. the position value is
referenced to the actual position
Only for the Z axis: Drill through without position value
specification
13
205