Defining Presets - HEIDENHAIN POSITIP 8013 ACTIVE Operating Instructions Manual

10
10.3

Defining presets

You can define presets on a workpiece in the Manual Operation mode in the
following ways:
Probe a workpiece with a HEIDENHAINKT 130 Edge Finder. Use this method to
automatically enter the presets into the preset table.
Touch a workpiece with the tool. Use this method to define the respective tool
position as a preset.
Requirements:
A workpiece is clamped on the machine tool
The reference mark search was successfully completed
A wizard assists you in setting presets by probing.
The following functions are available for probing a workpiece:
Icon
168
The setup engineer (Setup) may have already made settings in the
preset table.
Further information: "Creating a preset table", Page 137
When touching the workpiece with a tool, the product uses the
parameters stored in the tool table.
Further information: "Creating a tool table", Page 134
Function
Probe the edge of a workpiece
(one probing procedure)
Determine the centerline of a
workpiece
(two probing procedures)
Manual operation | Defining presets
Scheme
HEIDENHAIN | POSITIP 8013 ACTIVE | Operating Instructions | 01/2018