Table of Contents
Advertisement
15
15.6.22 Inputs (S)
Path:
Parameters
Enable digital movement
commands
Spindle start
Spindle stop
Movement commands from
analog input
Input for analog movement
commands
Umax
Fmax
Digital enable inputs
Spindle ready
Spindle interrupt
Spindle protection device
264
Settings ► Axes ► S ► Inputs
Explanation
Use of the digital movement commands
Settings: ON or OFF
Default value: OFF
Assignment of the digital input for the spindle start according to
pin layout
Default value: Not connected
Assignment of the digital input for the spindle stop according to
pin layout
Default value: Not connected
Configuration of the movement commands of external input
devices (such as a joystick) via the analog input
Assignment of the analog input for the movement commands
according to pin layout
Default value: Not connected
Maximum voltage that is output at the analog output
Setting range: 1000 mV ... 10000 mV
Default value: 9000
Definition of the maximum permissible feed rate
Setting range: 100 mm/min ... 2000 mm/min
Default value: 2000
Configuration of the digital inputs for the spindle enable
Assignment of a digital input; indicates that the spindle is in
reliable condition
Default value: Not connected
Assignment of a digital input; in active state it immediately
disconnects from power the configured analog output of the
spindle. A spindle movement is stopped without a ramp, axes
with automatic traverse are stopped if applicable and spindle
activation is prevented.
The machine tool builder is responsible for the
immediate stopping of the spindles.
Default value: Not connected
Assignment of a digital input; indicates whether an existing
spindle protection device is open or closed. This signal influ-
ences error messages and program run.
The machine tool builder is responsible for the
immediate shutdown of the spindles with opened
spindle protection.
Default value: Not connected
HEIDENHAIN | POSITIP 8013 ACTIVE | Operating Instructions | 01/2018
Settings | Axes
Advertisement
Table of Contents
