Sensors; Touch Probe - HEIDENHAIN POSITIP 8013 ACTIVE Operating Instructions Manual

15

Sensors

15.3
This chapter describes settings for configuring the sensors.

Touch probe

15.3.1
Path:
Parameters
Touch probe
Always use touch probe for
probing
Length
Diameter
240
Settings ► Sensors ► Touch probe
Explanation
Selection of the edge finder
Settings:
NONE
KT 130
Default value: NONE
Definition whether the edge finder should always be used for
probing
Setting range: ON or OFF
Default setting: OFF
Length offset of the edge finder
Setting range: ≥ 0.0001
Default value: 0.0000
Diameter of the edge finder
Setting range: ≥ 0.0001
Default value: 0.0000
HEIDENHAIN | POSITIP 8013 ACTIVE | Operating Instructions | 01/2018
Settings | Sensors