Table of Contents
Advertisement
Commissioning | Logging in for commissioning
7.2
Logging in for commissioning
User login
To commission the unit, the OEM user must log in.
If "Reference mark search after unit start" is active, then all of the
unit's functions will be disabled until the reference mark search is
successfully completed.
Further information:
If the reference mark search is active on the product, a wizard will ask you to
traverse the reference marks of the axes.
After logging in, follow the instructions of the wizard
The Reference symbol stops blinking on successful completion of the reference
mark search
Further information:
The default language for the user interface is English. You can switch the user
interface to the desired language.
HEIDENHAIN | POSITIP 8013 ACTIVE | Operating Instructions | 01/2018
Tap User login in the main menu
If required, log out the user who is currently logged in
Select the OEM user
Tap the Password input field
Enter the password "oem"
If a password other than the default password
has been assigned to the user, ask a Setup user
or OEM user for the assigned password.
If the password is no longer known, contact a
HEIDENHAIN service agency.
Confirm entry with RET
Tap Log in
The user is logged in
The unit now opens the Manual operation operating mode
"Reference marks (Encoder)", Page 256
"Activating the reference mark search", Page 93
Tap Settings in the main menu
Tap User
The logged-in user is indicated by a check mark
Select the logged-in user
The language selected for the user is indicated by a national
flag in the Language drop-down list
Select the flag for the desired language in the Language
drop-down list
The user interface is displayed in the selected language
7
85
Advertisement
Table of Contents
