Overview - HEIDENHAIN POSITIP 8013 ACTIVE Operating Instructions Manual

9
9.1

Overview

This chapter describes the production of an example workpiece. While you
produce the example workpiece, this chapter leads step by step through the
product's various operating modes with use of various machining options. You
need to carry out the following machining steps for successful production of the
flange:
Machining step
Determine preset 0
Process a through hole
Process a rectangular pocket
Process a fit
Determine preset 1
Process a bolt hole circle
Process a row of holes
Figure 26: Example workpiece
This chapter does not describe processing of the outside contour of the example
workpiece. It is presumed that the outside contour is already machined.
146
For a detailed description of the individual activities, please refer to the
chapters "Manual operation", "MDI mode", "Programming" and "Program
run".
Make sure that you have read and understood the "Basic Operation"
chapter before performing the activities described below.
Further information: "Basic operation", Page 53
Mode of operation
Manual operation
Manual operation
MDI mode
MDI mode
Manual operation
Programming and program run
Programming and program run
HEIDENHAIN | POSITIP 8013 ACTIVE | Operating Instructions | 01/2018
Quick Start | Overview