Conducting The Reference Mark Search - HEIDENHAIN POSITIP 8013 ACTIVE Operating Instructions Manual

Manual operation | Conducting the reference mark search
10.2

Conducting the reference mark search

With the help of reference marks, the unit can assign axis positions of the encoder
to the machine.
If no reference marks for the encoder are provided by a defined coordinate system,
you need to perform a reference mark search before you start measuring.
If "Reference mark search after unit start" is active, then all of the
unit's functions will be disabled until the reference mark search is
successfully completed.
Further information:
If the reference mark search is active on the product, a wizard will ask you to
traverse the reference marks of the axes.
After logging in, follow the instructions of the wizard
The Reference symbol stops blinking on successful completion of the reference
mark search
Further information:
Starting the reference mark search manually
A manual reference mark search can be performed only by the Setup
and OEM user types.
If the reference mark search was not performed on startup, you can start it
manually later.
HEIDENHAIN | POSITIP 8013 ACTIVE | Operating Instructions | 01/2018
"Reference marks (Encoder)", Page 256
"Activating the reference mark search", Page 93
Tap Settings in the main menu
Open in the sequence
Axes
General settings
Reference marks
Tap Start
Existing reference marks are cleared
The Reference symbol blinks
Follow the instructions of the wizard
The Reference symbol stops blinking on successful
completion of the reference mark search
10
167