Block Types; Positioning - HEIDENHAIN POSITIP 8013 ACTIVE Operating Instructions Manual

11
11.2

Block types

You can use the following block types for machining in the MDI mode:
Positioning functions
Machining patterns
11.2.1

Positioning

You can manually define position values for positioning. Depending on the
configuration of the connected machine tool, you can then move the tool to these
positions either automatically or manually.
The following parameters are available:
Positioning block
Parameter
R0
R+
R-
180
In the appropriate input fields you can load the current axis position with
Actual position capture.
Description
Tool radius compensation disabled (default setting)
Positive tool radius compensation; the traverse path is
increased by the tool radius (outside contour)
Negative tool radius compensation; the traverse path is
decreased by the tool radius (inside contour)
Incremental position value, i.e. the position value is
referenced to the actual position
Only for the Z axis: Drill through without position value
specification
HEIDENHAIN | POSITIP 8013 ACTIVE | Operating Instructions | 01/2018
MDI mode | Block types