15.6.13 Reference Point Displacement; Linear Error Compensation (Lec) - HEIDENHAIN POSITIP 8013 ACTIVE Operating Instructions Manual

Settings | Axes

15.6.13 Reference point displacement

Settings ► Axes ► X or Y or Z ► Encoder ► Reference marks ►
Path:
Reference point displacement
Parameters
Reference point displacement
Reference point displacement
Current position for reference
point shift

15.6.14 Linear error compensation (LEC)

Settings ► Axes ► X or Y or Z ► Error compensation ►
Path:
Linear error compensation (LEC)
Parameter
Compensation
Nominal length
Actual length
HEIDENHAIN | POSITIP 8013 ACTIVE | Operating Instructions | 01/2018
Explanation
Activation of offset calculation between reference mark and
datum of the machine
Setting range: ON or OFF
Default value: OFF
Manual input of the offset (in mm or degrees according to the
selected encoder type) between reference mark and datum
Default value: 0.00000
Capture of the current position as offset (in mm or degrees
according to the selected encoder type) between reference mark
and datum
Explanation
Mechanical influences on the axes of the machine are compen-
sated
Settings:
ON: Compensation is active
OFF: Compensation is not active
Default value: OFF
If Compensation is active, the Nominal length and
Actual length cannot be edited or generated.
Input field for nominal value in mm
Input field for actual value in mm
15
257