Table of Contents
Advertisement
Quick Start | Programming a bolt hole circle and row of holes (programming)
9.8.2
Programming the tool
9.8.3
Programming the bolt hole circle
HEIDENHAIN | POSITIP 8013 ACTIVE | Operating Instructions | 01/2018
Tap Add block on the toolbar
A new block is inserted below the current position
In the Block type drop-down list, select the Tool call block
type
Tap Tool number
The Tools dialog appears
Tap Drill 6.1
The associated tool parameters are applied automatically
The Tools dialog is closed
Tap Add block on the toolbar
A new block is inserted below the current position
In the Block type drop-down list, select the Spindle speed
block type
In Spindle speed, enter the value 3000
Confirm the entry with RET
Tap Add block on the toolbar
A new block is inserted below the current position
In the Block type drop-down list, select the Bolt hole circle
block type
Enter the following values:
Number of holes: 8
X coordinate of center: 0
Y coordinate of center: 0
Radius: 25
Confirm each entry with RET
Leave all the other values as defaults.
Tap END to terminate the input process
Tap Save program in the program management
The program is saved
9
159
Advertisement
Table of Contents
