Overview - HEIDENHAIN POSITIP 8013 ACTIVE Operating Instructions Manual

11
11.1

Overview

This chapter describes the "MDI (Manual Data Input)" mode of operation and how
to execute machining steps in single blocks in this mode.
Short description
The MDI mode enables you to execute precisely one single machining block. The
values to be entered into the input fields can be taken directly from a properly
dimensioned production drawing.
The functions provided by the MDI mode allow efficient single-part production. For
small-batch production, you can program the machining steps in the Programming
mode and then execute them in the Program Run mode.
Further information:
Further information:
Activation
178
Make sure that you have read and understood the "Basic Operation"
chapter before performing the activities described below.
Further information: "Basic operation", Page 53
Before you can use the product in the MDI mode, the presets must be
set in the Manual Operation mode.
Further information: "Defining presets", Page 168
"Programming", Page 203
"Program run", Page 193
Tap MDI in the main menu
HEIDENHAIN | POSITIP 8013 ACTIVE | Operating Instructions | 01/2018
MDI mode | Overview