Table of Contents
Advertisement
Commissioning | Steps for commissioning
7.3.2
Configuring the axes
Activating the reference mark search
The product uses the reference marks to reference the machine table to the
machine. If the reference mark search has been activated, a wizard appears on
startup of the product and asks the user to move the axes for the reference mark
search.
Requirement:
configured in the axis parameters.
The automatic reference mark search on startup of the product can be
canceled depending on the configuration.
Further information:
Configuring axis parameters for encoders
Before you start measuring, you need to configure the parameters of the
connected encoders for the individual axes.
The parameters of HEIDENHAIN encoders, which are typically connected to the
unit, can be found in the overview of typical encoders.
Further information:
The configuration procedure is the same for each axis. The following
section describes only the configuration of the X axis.
HEIDENHAIN | POSITIP 8013 ACTIVE | Operating Instructions | 01/2018
The installed encoders have reference marks that have been
"Reference marks (Encoder)", Page 256
Tap Settings in the main menu
Tap Axes
Open in the sequence
General settings
Reference marks
Use the ON/OFF sliding switch to activate Reference mark
search after unit start
The reference marks must be traversed every time the
product is started
The functions of the product will only be available after the
reference mark search has been completed
On successful completion of the reference mark search, the
display of the reference marks changes
"Overview of typical encoders", Page 96
Tap Settings in the main menu
7
93
Advertisement
Table of Contents
